User Manual - Leaf Buds Air

POWER ON/OFF
To power ON, Open the case and they will automatically get powered ON.

To power OFF, Insert the earbuds into the charging case and close the lid.The earbuds will automatically get turned off.
NOTE : If TWS don't get powered on automatically, Tap Multifunction Button for 3 sec. on both the earbuds.

BLUETOOTH PAIRING MODE
1.open the case it will automatically gets powered ON
2. Now wait 2 seconds for earbuds to go in pairing mode. White and Blue LED will start blinking on either side earbud.
3. Now, go to bluetooth settings of your phone and select Leaf Buds Air from the list of bluetooth devices.
4. After successful connection you will hear a prompt tone “Leaf Connected”.
5. Now play any music from your phone and you will hear the music in both the earbuds.

TROUBLESHOOT/FAQs

Q.1 Both the earbuds are not connecting to each other or only 1 earbud is working at a time. What should I do?
A.1 Please follow Reset procedure.

Q.2 I am able to see 2 Leaf Buds Air in the list of available devices in bluetooth settings, but only 1 is able to connect. What should I do?
A.2 Please follow Reset procedure.

Q.3 I am facing sound imbalance issues. What do I do?
A.3 ..For sound imbalance, try the reset procedure mentioned.

Q.4 Do my Leaf Buds Air support Dual/Stereo calling?
A.4 Leaf Buds Air have Bluetooth v5.4 and thus supports Stereo calling.

Q.5 Are my Leaf Buds Air water resistant?
A.5 Leaf Buds Air come with IPX5 rating which makes it sweat resistant.

CHARGING EARBUDS WITH CASE
NOTE : Do not use power bank for charging Leaf Buds Air

Leaf Buds Air come with a built-in rechargeable battery, prior to usage, it is recommended to charge the battery fully for the first time.
1. Open the case and make sure it is charged.
2. Place the earbuds in charging case and charging of earbuds will start automatically.
3. When charging of earbuds is done, LED will TURN OFF automatically if not connected to phone
4. It will take about 1.5 hrs. to fully charge the earbuds.

CHARGING THE CASE

1.Plug in the C-type cable in the charging port to charge the case.
2. While charging the case, the white LED indicator blinks to show the charging status.
3. The LED indicator will switch off when the charging case is fully charged.

ATTENTION : Do not charge products with Turbo charger, only charger with 5V, 1A output chargers.