POWER ON/OFF
To power ON, Take earbuds out of the case, and they will automatically get powered ON.

To power OFF, Tap the Multifunction Button for about 5-6 seconds to turn OFF the earbuds.
NOTE : If TWS don't get powered on automatically, Tap Multifunction Button for 3 sec. on both the earbuds.

BLUETOOTH PAIRING MODE
1. Take out both the earbuds from the charging case & the earbuds will get powered ON automatically
2. Wait for the earbuds to connect with each other.
3.On successful connection the earbuds LED will start blinking BLUE , which shows that earbuds are connected with each other, but not yet connected to your device.
4. Now, go to bluetooth settings of your phone and select Leaf Buds X2 from the list of available bluetooth devices.
5.After successful connection you will hear a prompt tone “ Leaf Connected ”.
6. Now play any music from your phone and you will hear the music in both the earbuds.

TROUBLESHOOT/FAQs

Q.1 Both the earbuds are not connecting to each other or only 1 earbud is working at a time. What should I do?
A.1 Put both earbuds back in the charging case and wait for 5 minutes. Now take them out and wait for 1 minute, they will get connected to each other and LED will be blink on only one earbud.

Q.2 I am able to see 2 Leaf Buds X2 in the list of available devices in bluetooth settings, but only 1 is able to connect. What should I do?
A.2 Check if LED is blinking on both earbuds while taking out. If it is blinking on only one earbud, it means they are connected to each other.

Q.3 I am facing sound imbalance issues. What do I do?
A.3 ..For sound imbalance, try the reset procedure mentioned.

Q.4 Do my Leaf Buds X2 support Dual/Stereo calling?
A.4 Leaf Buds X2 have Bluetooth 5.1 and thus supports Dual calling.

Q.5 Are my Leaf Buds X2 water resistant?
A.5 Leaf Buds X2 have IPX4 Protection and are sweatproof.

CHARGING EARBUDS WITH CASE
NOTE : Do not use power bank for charging Leaf Buds X2

Leaf Buds X2 come with a built-in rechargeable battery, prior to usage, it is recommended to charge the battery fully for the first time.
1. Open the case and make sure it is charged.
2. Place the earbuds in charging case and charging of earbuds will start automatically.
3.When charging of earbuds is done, LED will glow WHITE.
4. It will take about 1 hrs. to fully charge the earbuds.

CHARGING THE CASE

1.Plug in the cable in the charging port to charge the case.
2. When charging of earbuds is done, LED will glow WHITE.
3.When case is fully charged, LED will glow.

ATTENTION : Do not charge products with Turbo charger, only charger with 5V, 1A output chargers.